Marvell 86868 SDIO firmware loading failure

[Dan Williams]

On Tue, 2009-10-13 at 22:40 +0200, Maurus Cuelenaere wrote:
> Op 13-10-09 22:24, Dan Williams schreef:
> > On Tue, 2009-10-13 at 21:10 +0200, Maurus Cuelenaere wrote:
> >    
> >> Hi,
> >>
> >> I'm porting Linux 2.6.32 over to the SmartQ 7, an ARM11 MID running on the
> >> Samsung S3C6410 SoC.
> >>
> >> The board has a Universal Scientific Industrial WM-G-MR-09 wifi chip (see [1]),
> >> which has a Marvell 88W8686 as chipset (and is connected over SDIO).
> >>
> >> I've compiled the libertas drivers statically, but get these messages in the
> >> kernel log:
> >>
> >> [   11.200000] libertas_sdio mmc2:0001:1: firmware: requesting sd8686.bin
> >> [   18.880000] libertas: firmware wants 16 bytes
> >> [   18.880000] libertas: firmware wants 512 bytes
> >> [   18.970000] libertas: firmware wants 17 bytes
> >> [   18.970000] libertas: firmware helper signalled error
> >> [   19.050000] libertas: failed to load firmware
> >>
> >> (I'm using SD-8686-LINUX26-SYSKT-9.70.3.p24-26409.P45-GPL.zip, see [2])
> >>      
> > You're using that *driver*, or just the firmware from that driver
> > tarball?
> >    
> 
> Only sd8686.bin and sd8686_helper.bin
> 
> > What specific SDHC are you using?
> 
> This is a Samsung S3C6410 SDHCI, which follows AFAIK pretty much the 
> SDHCI spec.

Any chance you can use a regular laptop with a Ricoh SDHC to verify that
your 8686 hardware actually works along with the firmware you're trying?
The one thing we've found is that controllers rarely, if ever, follow
the spec to the letter.  Since the spec is ambiguous in some places too,
there's always room for multiple interpretations.

Dan