sdio 8686 firmware load problem.

[Jonathan Cameron]

Jonathan Cameron wrote:
> V8 and V9 firmware's from git repository are both giving the following debug.
> 
> libertas enter: lbs_init_module()
> libertas leave: lbs_init_module()
> libertas enter: if_sdio_init_module()
> libertas_sdio: Libertas SDIO driver
> libertas_sdio: Copyright Pierre Ossman
> libertas enter: if_sdio_probe()
> libertas sdio: class = 0x7, vendor = 0x2DF, device = 0x9103, model = 0xB, ioport = 0x10000
> libertas enter: if_sdio_prog_firmware()
> libertas sdio: firmware status = 0x0
> into sdio firmware load
> libertas enter: if_sdio_prog_helper()
> libertas_sdio mmc0:0001:1: firmware: requesting sd8686_helper.bin
> libertas sdio: waiting for helper to boot...
> libertas leave: if_sdio_prog_helper(), ret 0
> libertas enter: if_sdio_prog_real()
> libertas_sdio mmc0:0001:1: firmware: requesting sd8686.bin
> libertas sdio: firmware wants 16 bytes
> libertas sdio: firmware wants 17 bytes
> libertas sdio: firmware helper signalled error
> libertas: failed to load firmware
> libertas leave: if_sdio_prog_real(), ret -5
> libertas leave: if_sdio_prog_firmware(), ret -5
> libertas leave: if_sdio_probe(), ret -5
> libertas_sdio: probe of mmc0:0001:1 failed with error -5
> libertas leave: if_sdio_init_module(), ret 0
> 
> This was previously working with this board and the same kernel setup
> prior to switching from a scratch built filesystem etc to using openembedded.
> 
> Anyone have any suggestions on what might be happening?
> 
> Thanks,
> 
> Jonathan
Forgot to mention this is with 2.6.31-rc5